Remove the nuts on front fork and handlebar. As the fuel level falls, the float lowers and the needle valve unseats itself;. Turn the tank inner cover counterclockwise a little bit, dismantle it. Engine Idle speed is unstable 3. Disassembling and assembling the front brake-disk. Remove the intake pipe from the Cylinder head cover. Fuel level too low 4.
Measure the resistance value of terminals. Follows the opposite procedure of dismantling. Turn off the engine after warm up. Wheel bearing 4 Periodical Maintenance Table 5 Troubleshooting 1. Remove the crankcase cover 6. The bearing of gear box is loose. Take off the air cleaner fixing screws.
Take off the screws of left cover, remove the left cover. Take off the driving gear and chain. Assemble the disk follows the disassembling procedure. If there is too much white fume from exhaust system, which means too much Carbon piled up on the spar plug or the oil quality is not good. We wish to attract regard what our website does not store the eBook itself, but we grant url to the website where you can download either reading online. Remove right body cover 3.
Limit of use: replace a new one when over 14. Loosen 3 bolts of rear luggage bracket, dismantle it. Front fork checking: If it is bent or cracked, please replace with a new one. But connect the positive cable + first, then connect the Negative cable - when assembling. Remove the M6 screws 4 3.
Be careful not to scratch the piston and not to break the piston ring. Assemble the clutch : follows the opposite procedure of dismantling. Remove five screws of isolating plate. Installing piston and piston rings 1. Outer diameter measurement: Limit of use:change it as it Is above 33.
This can make sure the engine runs smoothly. Insert the nozzles squarely to the battery. Remove the throttle cable, then the fuel pipe from the carburetor. Take off the left cover. Note: Put some grease onto the inner cable before assembling.
Withdraw the windshield decorated cover. Take off the left cover. The gears of oil pump should be lubricated by grease. Handlebar steering astrayed when running. Note: Do not start the engine when the air cleaner is Not installed. Clean up the gear box. Locking nut of clutch M12: 4.
Remove the lock pin, cylinder head gasket. The operation data information C. Check connecting rod small end 1 lnstall piston pin, bearing onto the connecting rod small end, then check the looseness of the piston pin. Remove the four M7-nut on the cylinder head, then remove the cylinder head and cylinder head gasket. Remove the retaining C-type Ring. Disassemble the final transmission mechanism: 1. To prevent clip falling down the crankcase, use clothes to cover the crankcase.