The side airbag could injure you as it deploys from the side of the seatback. Do not tow with a slingbelt. Turn the heater fan on in both vehicles to protect from any electrical surges. Department of Transportation-Tire quality grades: The U. Refer to Side airbag system later in this chapter.
Speed sensitive volume: Radio volume automatically adjusts according to vehicle speed to compensate for road and wind noise. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. Pull the bulb straight out. Fan speed adjustment: Controls the volume of air circulated in the cabin. If your vehicle is to be towed from the rear using wheel lift equipment, the front wheels drive wheels must be placed on a dolly to prevent damage to the transmission.
Reach under the side of the bumper, grasp the bulb socket and turn it counterclockwise to remove 4. Away from home If you own a Ford or Mercury vehicle and are away from home when your vehicle needs service, or if you need more help than the authorized dealer could provide, after following the steps described above, contact the Ford Customer Relationship Center to find an authorized dealer to help you. Turn off the engine, remove the fuel filler cap, align the cap properly and reinstall it. They may seriously hurt themselves. Lower the wheel by turning the jack handle counterclockwise.
Make sure all running lights, brake lights, turn signals and hazard lights are working. Side airbags are designed to inflate in side-impact collisions, not roll-over, rear-impact, frontal or near-frontal collisions, unless the collision causes sufficient lateral deceleration. Set the parking brake, depress the clutch and place the gearshift in 1 First. Canadian customers who require roadside assistance, call 1—800—665—2006. Ensure that the cables are clear of fan blades, belts, moving parts of both engines, or any fuel delivery system parts.
A higher energy level is used for the most severe impacts. Do not leave children, unreliable adults, or pets unattended in your vehicle. If not, contact a local tire dealer. Turn the bulb socket counterclockwise and pull it out. Wet brakes do not stop the vehicle as quickly as dry brakes. Take your vehicle to an authorized dealer as soon as possible.
Failure to follow these instructions may interfere with the passenger seat sensing system. In a rollover crash, an unbelted person is significantly more likely to die than a person wearing a seat belt. Exhaust fumes can be toxic. Exhaust fumes can be toxic. Press and hold for continuous seek functionality. Gently pull the lamp assembly away from the vehicle.
For more information on top tether straps and anchors, refer to Attaching safety seats with tether straps in this chapter. The vehicle has run out of fuel—the engine may misfire or run poorly. Copyright © 2006 Ford Motor Company. To remove a fuse, use the fuse puller tool provided on the power distribution box cover located in the engine compartment. If the safety seat in not anchored properly, the risk of a child being injured in a collision greatly increases.
Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Restart the engine and take your vehicle to an authorized dealer. Always open the garage door before you start the engine. Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Replace wiper blades at least once per year for optimum performance. Copyright © 2006 Ford Motor Company. To remove a fuse, use the fuse puller tool provided on the power distribution box cover located in the engine compartment.
Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Put the indicator back in and ensure it is fully seated. The fuel system may be under pressure. The fuel gauge may vary slightly when the vehicle is in motion or on a grade. Reach under the side of the bumper, grasp the bulb socket and turn it counterclockwise to remove 4.