Failed main circuit breaker or ignition switch, check for loose connections and continuity. Depending in which direction want ride, have press button into left right position. Remove the setting bolt of rear cushion. Faulty or corroded kill switch. .
In this case, push the starter button a few times without turning the throttle grip. Install the setting bolts of crankcase. Severely discharged or a damaged battery should have 12. For the customer file of the dealer Vehicle owner: Please write in capital letters Surname:. D O N O T T E A R O F F Vehicle owner: Please write in capital letters Surname:. Good luck and have a wonderful day. Remove the bearing of crankcase by using a bearing pulley.
Pour plus d'informations au sujet de votre question et t? Remove the cylinder air should. To ensure more comfortable and safer operation, we recommend to read this manual carefully prior to operation. Checkup of oil- and fuel level 3. If it has one, fill the fluid resivoir and have someon apply the rear brake. Let the oil drain out in smoothly then tight the screw. Remove the setting bolt of oil pump.
The coil is normal if there is continuity. Disconnect the spark plug cap. Remove the idle gear plate. The gas cap is not venting properly or fuel tank venting system blocked, loosen gas cap and go for a test ride. Remove the setting nut of clutch outer. Drain the gear oil Remove the mission cover.
Good luck and have a nice day. Disconnect the earth wire of engine. For the brake sensor 2. Remove the kick pinion with the kick friction spring. Install the crankshaft into the left crankcase. Before starting to ride your new vehicle, we recommend to read this user guide very careful.
Check the current of air route as show. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged. If the fuel level reaches the reserve fuel area, the fuel indicator is lighting on the display. Connect the oil pump control cable and adjust the clearance. For the front fork ii.
For the front fork ii. Coat the cylinder and piston ring with the engine oil. Remove the oil pump control cable. Install the oil pump onto the crankcase. Remove the setting bolt of oil pump. Check the performance of the motor.
Disconnect the earth wire of engine. How to stop and park 1. Loose the carburetor cap of throttle valve. Coat the cylinder and piston ring with the engine oil. Spark plug gap too close or too wide.