Performance and econ- omy are decreased because the hull of the boat is pushing the water and there is more air drag. Consult your sition not tilted. Any reprinting or unauthorized use without the written permission of Yamaha Motor Co. Pulling the le- ver back from neutral engages reverse. Is outboard motor mounted at incorrect A.
Install a spare fuse of the proper amperage. Oil pressure 4-stroke models Do not continue to run the engine if the 8. Consult your Yamaha deal- er or boat manufacturer for further informa- tion on determining the proper mounting height. Otherwise the outboard motor could fall back down suddenly if oil in the power trim and tilt unit or in the power tilt unit loses pressure. The starter can also be dam- aged.
If the oil level is correct and the alert device does not switch off, consult your Yamaha dealer. Consult low oil pressure alert device has activat- your Yamaha dealer if the problem can- ed. Inspect the external anodes periodically. Have serviced by a Yamaha dealer. Warm it up and keep the idle speed for 5-10 minutes. The engine will continue to run at idle until the le- ver is moved 22. For twin type, outboard motor up, and then tilts it up.
Have serviced by a Yamaha dealer. Otherwise, cooling water will leak out during operation, causing the engine to overheat. Have serviced by a Yamaha dealer. Water detection-alert indicator Yamaha dealer. Avoid distribution can compromise the boats han- boating in hazardous weather. Using the trim and tilt switch and slowly tilt the out- power trim and tilt switch on the bot- board motor down. Consult your Yamaha dealer if the new fuse immediately blows again.
. Stop the engine and leave it for 5-10 minutes. If your boat Yamaha dealer for inspection and replace- is equipped with the digital speedome- ment of internal anodes attached to the pow- ter, the voltmeter and low battery alert er unit. The outboard motor could shake loose from the tilt sup- port and fall. Have serviced by a Yamaha dealer.
Check that all of the cowling lock levers are pulled outward. Otherwise the boat could move in the opposite direction from that expected. Overloading or incorrect weight weather forecasts before boating. Severe injury could occur if the outboard motor accidentally falls. Yamalube — Take care of your Yamaha with legendary Yamalube oils, lubricants, and care products. Have outboard motor adjusted to proper Q. Do not attempt to diagnose any problems yourself.
Consult a Yamaha dealer for replacement of external anodes. Is steering pivot loose or damaged? Remove scales from the surfaces of the anodes. You should periodically remove and check the spark plug because heat and deposits will cause the spark plug to slowly break down and erode. This ethanol and water outboard motor is calibrated to run properly. Low battery voltage-alert indicator The Command Link Plus Display hereinafter 8.
Are spark plugs fouled or of incorrect A. Multifunction display oil quantity is maintained, consult your 4. If the motor cannot be trail- ered in the normal running position, use an additional support device to secure it in the tilt position. The fuel management meter has the func- For details, consult your Yamaha dealer. Consult your Yamaha dealer if the oil level is not at the proper level or if it ap- pears milky or dirty. Remove the apron from starboard side as shown in the illustration.